Cut the beading to length, mitring the corners, and either pin or glue it to the existing skirting or wall. Don't forget to leave the 10mm expansion/contraction gap between the edge of the floor and the existing skirting or wall.

Do NOT pin or glue the beading to your floor - your floor must be allowed to move freely underneath the beading.

Gluing is best so use an adhesive with good grab strength. Where the length of the beading required exceeds the length of the beading section (i.e. 2700mm), either butt the two lengths tight up to one another or cut one length at 45º and the other at 135º and then glue the angles together to form a flush joint.

Wherever necessary, return the beading as shown in the diagram rather than leaving an exposed edge.

Choose from twelve matt-lacquered coloured finishes for this 2700mm x 19mm x 19mm solid oak scotia beading. The perfect finish for your floor!

The ideal solution for finishing off your floor and getting that professional look.

Key features:

2700mm x 19mm x 19mm oak scotia beading, ideal for finishing off around the edge of a room
Solid oak scotia profile available in twelve matt-lacquered coloured finishes
Easy to fit - use Griptite to glue to your skirting boards
Covers the standard expansion/contraction gap with ease

Choose from any one of these twelve stunning finishes:

Golden Brown	Streaky Grey	Cloudy Oak	Ebony
Blond Oak	Burnt Oak	Dark Grey	Classic Oak
Tudor Oak	Mahogany	Light Golden Oak	Stormy Oak

Threshold/trim profile details
Size	Overall size - 2700mm x 19mm x 19mm
Material	Solid oak oak scotia beading available in twelve matt-lacquered coloured finishes
Installation method	Apply a bead of Griptite to the rear of the section and then press in place against the skirting board. N.B. Do NOT glue to the floor - your floor must be allowed to move freely under the scotia beading.